Description
Unleash the true performance potential of MoTeC on the Mercury Racing Outboard platform now! MoTeC have put together an M150-based Development Kit for the 450R and 500R Supercharged V8 Mercury engines. Increased Power/Speed and control over the Guardian System are the main benefits. A recent install we did on a 500R resulted in a speed increase of over 6.5 mph over stock.
This Kit provides all the wiring, modules and mounting hardware needed to switch out the factory ECU, using a MoTeC M150 with a targeted Firmware Package specifically optimized for the Mercury Racing 450/500R.
Added features include:
- Knock Sensing and Control
- Ignition Timing Adaptation for peak performance depending on fuel grade
- Cruise Control
- Onboard Data Logging – Level 2 (Up to 200 Channels at 200 hz)
- Nitrous Oxide Control
- Launch Control – Prop Slip Limiting
- Full Control over Guardian Mode restrictions
Along with fuel, ignition, throttle and drive trim control, this solution also supports other OE ECU features, including:
- Key Start Via OE CAN
- Full dash functionality including warnings and run time for maintenance
- Compatibility with Smart Craft/Vessel View/Garmin/SimRad Screens
- Boost Control
- Integration with multi engine boats via CAN
- Stern Leg Position Monitoring
- Multi Engine Synchronization
Included in the Developer Kit – MoTeC M150 ECU with Targeted Mercury Racing Firmware, Level 2 Data Logging, LTC Lambda to CAN Module to read factory installed Lambda Sensor, IGN4 Ignitor Module to trigger coils, Relay Kit, Plug and Play Harness to adapt MoTeC M150 to factory loom in place of factory ECU, Bosch Knock Sensor for Onboard Knock Control, related mounting hardware.
The Kit is meant to be installed by one of our staff or a trained technician working with our staff. Requires onsite setup and calibration – billed separately.
Kits available now for these Mercury Outboards:
- 175HP V6
- 200HP V6
- 225HP V6
- 200HP V8
- 225HP V8
- 250HP V8
- 300HP V8
- 360HP V8
- 450HP V8
- 500HP V8
